Specifications

• When using abrasive nylon wheel brushes, optimum aggression is obtained and wheel life maximized when the work-piece penetrates into the face of the brush approximately 1/8 of the trim length. The sides of the Nylox filament actually do the work. To achieve a maximum edge radius and complete burr removal, parts should be buried into a slow running brush face.
• When using abrasive nylon disc brushes, a good starting point for a depth of penetration between the brush face and work surface is 0.100". This depth of interference produces the best compromise between aggression and brush life. The feed rate starting point of Nylox disc brushes is 18"/minute. This feed rate should then be adjusted faster or slower to achieve optimum operating conditions. On soft materials and parts with small burrs, high feed rates can normally be achieved.